LED lamp with 5 installation methods

1 Four-line LED light with a total of four wires, three rows of lights (note that not four rows of lights ~ ~), each row 1 24 lights, 24 * 3 = 72. Because the power of each lamp is 0.05W, the power of the 72-ball LED strip is: 72*0.05=3.6W.

2 four-line LED lights with a bandwidth of about 22mm, a thickness of about 8mm, a weight of about 0.25kg/m (4 meters a kilogram)

3 Each LED strip must be equipped with a special plug (plug with a transformer); when connecting, it is necessary to remove the bright plastic cover and connect it after the test light is connected. Can not cut directly with the lid connected, so easily short circuit!

4 There are "hinge shears" signs per meter, which can only be cut off when the signs are cut. If the shearing or shearing is wrong, it will cause one meter not to shine! Some will be biased when playing the logo. It is best to take a careful look at the status of the logo before cutting it, and cut it off in the local area where there is no convergence. Look carefully to see it.

When the 5 LED lamp is equipped with a device, it is usually placed in a lamp trough, and straightening is possible, and it can also be fixed with a string or a thin wire. If you need exterior or vertical installation, you need another wind purchase clip and tail plug. The original clip is fully transparent, and it is best to put waterproof glass glue on the plug and plug after the device is installed, so that the waterproof function is better.