Diesel generator set professional information report: self-starting function: When the mains power fails (or other important unit start signal), after delay confirmation, the unit starts automatically (1~8 times adjustable, the first start success rate is >99%) ), automatically confirm that the power supply of the generator set is normal, and supply power to the load. After the utility power returns to normal, the automatic cooling shutdown is confirmed by delay (cooling downtime is adjustable from 0 to 300s). At the same time, it has numerous protection functions, digital display voltage, current, frequency, power, power factor, running time, battery voltage, speed and other parameters.
There are two ways to boot from the boot:
1. The power is turned on. This is the same as the basic generator set. The method is to turn on the power first. After twisting the key, press the start button. When the machine starts successfully, press the emergency stop button to stop and turn off the key alarm.
2. Key activation: first rotate the key clockwise, release the key after the machine starts normally, then press the module “Menu†button to enter the module settings, press the prompt “0318â€, press “Up†and “Downâ€. â€Check to see if the oil pressure and water temperature indicators are normal. After confirming the normal, turn the “lift†speed switch to the full speed direction. When the frequency rises to 51.5-52HZ, it indicates that the highest speed has been reached. Normally, the machine is running well and the performance is successfully debugged. After running for a period of time to determine that there is no fault and need to stop, first, the unit operator will slowly rotate the “speed up†knob to the idle direction, and the unit will slowly slow down. When the value is restored to the position set by the factory before leaving the factory, The "Emergency Stop" button is stopped.
Ethernet Slip Ring is a device that allows Ethernet signals to be transmitted through a rotating assembly. This device is typically used in applications where it is not possible or practical to run Ethernet cables, such as in an application where the cables would have to travel through a hazardous area. It converts the regular Ethernet signals into rotary signals, which are then transmitted through the rotating assembly.
There is a growing trend in the industry for Ethernet slip rings. Ethernet slip rings are currently being used to interconnect computer networks. A slip ring is a transmission device that uses a counter-rotating encircling belt to transfer power and data between two or more devices.
Senripgrid Conductive Slip Ring has the following characteristics Direct unplugging of the RJ45 connector Upon reaching eight simultaneous ports, follow the standard cable connection method Work with either copper or gas-liquor joints Transmission to the external network (10M, 100M, 1Km Base T).
Ethernet Slip Ring,Generator Collector Rings,Through Bore Rotary Union,Rotary Pressure Joint
Dongguan Oubaibo Technology Co., Ltd. , https://www.sliprobo.com