Pump Accessories Float Switch Model (DVFS01)

Model NO.: DVFS01
Trademark: Leading science technology
Origin: China
HS Code: 90328990
Model NO.: DVFS01
Trademark: Leading science technology
Origin: China
HS Code: 90328990
Main Specifications:
Rated voltage / Frequency: AC230V 50Hz/60Hz
Max. Current: 16(4)A
Protection Grade: IP68
Max. Working temperayure: 55 centigrade


Company  Information 
1)Brief introduction: as the supplier of pump control panel and control accessories, major products including: Intelligent Single / Dual Pump Control Panel, Motor Protector / Starter , Reverse Osmosis Controller, Anti-Clogging Reversal Pump Control Panel 
More information, please visit: www.leading-china.com
 2)Our location and communication
From Guangzhou to Changsha takes 1hour by air, 2.5hour by high speed train
From Shanghai to Changsha takes 1.5hour by air, 5hour by high speed train
From Beijing to Changsha takes 2.5hour by air
From Hong Kong to Changsha takes 2hour by air

Pump Accessories Float Switch Model (DVFS01) Main Specifications:
Rated voltage / Frequency: AC230V 50Hz/60Hz
Max. Current: 16(4)A
Protection Grade: IP68
Max. Working temperayure: 55 centigrade


Company  Information 
1)Brief introduction: as the supplier of pump control panel and control accessories, major products including: Intelligent Single / Dual Pump Control Panel, Motor Protector / Starter , Reverse Osmosis Controller, Anti-Clogging Reversal Pump Control Panel 
More information, please visit: www.leading-china.com
 2)Our location and communication
From Guangzhou to Changsha takes 1hour by air, 2.5hour by high speed train
From Shanghai to Changsha takes 1.5hour by air, 5hour by high speed train
From Beijing to Changsha takes 2.5hour by air
From Hong Kong to Changsha takes 2hour by air

Pump Accessories Float Switch Model (DVFS01)

A circulator is a passive non-reciprocal three- or four-port device, in which a microwave or radio frequency signal entering any port is transmitted to the next port in rotation (only).


Applications

Isolator

When one port of a three-port circulator is terminated in a matched load, it can be used as an isolator, since a signal can travel in only one direction between the remaining ports.[12] An isolator is used to shield equipment on its input side from the effects of conditions on its output side; for example, to prevent a microwave source being detuned by a mismatched load.

Duplexer

In radar, circulators are used as a type of duplexer, to route signals from the transmitter to the antenna and from the antenna to the receiver, without allowing signals to pass directly from transmitter to receiver. The alternative type of duplexer is a transmit-receive switch (TR switch) that alternates between connecting the antenna to the transmitter and to the receiver. The use of chirped pulses and a high dynamic range may lead to temporal overlap of the sent and received pulses, however, requiring a circulator for this function.

In the future-generation cellular communication, people talk about full-duplex radios, where signals can be simultaneously transmitted and received at the same frequency. Given the currently limited, crowded spectrum resource, full-duplexing can directly benefit the wireless communication by twice of the data throughput speed. Currently, the wireless communication is still performed with "half-duplex", where either the signals are transmitted or received at different time frames, if at the same frequency (typically in radar), or the signals are simultaneously transmitted and received at different frequencies (realized by a set of filters called a diplexer).


Reflection amplifier

reflection amplifier is a type of microwave amplifier circuit utilizing negative differential resistance diodes such as tunnel diodes and Gunn diodes. Negative differential resistance diodes can amplify signals, and often perform better at microwave frequencies than two-port devices. However, since the diode is a one-port (two terminal) device, a nonreciprocal component is needed to separate the outgoing amplified signal from the incoming input signal. By using a 3-port circulator with the signal input connected to one port, the biased diode connected to a second, and the output load connected to the third, the output and input can be uncoupled.



Rf Circulator

Rf Circulator,Passive Device Circulator,High Isolation Circulator,High Power Circulator,Waveguide Circulator,Optical Circulator

CHENGDU JING XIN MICROWAVE TECHNOLOGY CO., LTD , http://www.cdjx-microwave.com